What it is and what it is not
An AC charging station is usually called a “charger”, but strictly speaking the battery charger is inside the vehicle. The EVSE does not convert the energy into the form the battery needs: it delivers it as alternating current and manages it. That is why it is technically supply equipment and not a charger.
Main functions
- Mechanical and electrical connection: connector, cable, and socket outlet or vehicle coupler.
- Basic communication with the vehicle: through a control pilot signal, the EVSE tells the vehicle what maximum current it can draw, and the vehicle indicates its state (connected, ready to charge).
- Protection: ground leakage detection, overcurrent protection and verification of ground conductor continuity before energizing.
- Interlock: the internal contactor only closes when the exchange with the vehicle confirms that it is safe; if the connector is removed or communication is lost, the power is cut.
Difference from DC charging
In DC fast charging, the equipment does contain the power electronics that convert the energy and negotiate with the battery. That equipment is also commonly called a charger in the strict sense. The term EVSE is used mainly for AC equipment.
What an engineer sees in practice
When testing an EVSE, a sequence can be observed: the equipment presents a pilot signal at rest, changes state when the vehicle connects, and only then closes the contactor. Equipment that energizes without that sequence, or that does not cut off on a simulated leak, has a safety problem. To verify these functions, vehicle simulators are used that reproduce the connector states without the need for a real car.
How to interpret a test result
A functional test compares the observed behavior with what the applicable standard requires for each state. Typical deviations are cutoff times outside what is expected, announced current different from the current delivered, or faults in the exchange with the vehicle. Always consult the edition in force of the standard that applies to your market.
Testing and connecting charging equipment involves hazardous voltages; this work must be done only by qualified personnel following the applicable regulations.