What sets them apart
Monocrystalline silicon is obtained by growing an ingot from a seed crystal, typically by the Czochralski method. Polycrystalline silicon is obtained by melting and solidifying in a mold, which produces many crystals joined at grain boundaries. Those boundaries promote carrier recombination and reduce the achievable cell efficiency.
What is seen in practice
- Monocrystalline silicon has higher efficiency, so it produces more power per square meter, which matters on roofs with limited area.
- The appearance differs: polycrystalline silicon looks mottled and bluish; monocrystalline silicon is more uniform and darker.
- The temperature coefficient depends on the model and the cell design more than on the crystal type, so it must be read from the datasheet.
Why polycrystalline is rarely discussed today
Advances in manufacturing narrowed the cost difference, and the market shifted toward monocrystalline technologies, including rear-passivated cells. Even so, polycrystalline installations remain in operation and are commonly encountered in diagnostic work.
How to decide between them
The choice starts from the power required and the area available. If area is the constraint, the higher efficiency is the better option. If area is not a constraint, what matters more is the cost per watt, the power warranty, the expected degradation and the module certification. A fair comparison is made between specific modules, using their nameplate data and test results, not between categories.
An important caveat
A module with a better type of silicon can perform worse if its manufacturing quality or internal mismatch is poor. I-V curve characterization and electroluminescence inspection make it possible to verify the actual quality, which cannot be inferred from the name of the material.