What it measures and why that combination
The typical four-sensor configuration covers the most frequent atmospheric hazards in confined spaces: oxygen (deficiency or excess), combustible gases (risk of fire or explosion), carbon monoxide and hydrogen sulfide (toxicity). It is not the only possible configuration, but it is the most common because these four hazards are frequent.
How it works inside
| Measurement | Usual sensor type |
|---|---|
| Oxygen | Electrochemical cell |
| Combustibles | Catalytic or infrared |
| Carbon monoxide | Electrochemical cell |
| Hydrogen sulfide | Electrochemical cell |
Each sensor delivers an electrical signal; a processor converts it into a reading and compares it with the alarm thresholds. The sample reaches the sensor by diffusion (the air enters on its own) or through a pump that draws it through a hose, which makes it possible to measure remotely before entry.
Alarms
There are normally audible, visual and vibrating alarms, with warning and danger levels. For oxygen they are configured in both directions: low and high. Some instruments also log readings and events, which is useful for reviewing what happened.
What it does not do
- It does not detect all hazards. Other toxic gases, specific vapors or combustible dusts are not covered unless there is a sensor for them.
- It does not identify the combustible gas; it only estimates proximity to the explosive limit.
- It does not replace ventilation, isolation or the rescue plan.
Maintenance that underpins confidence
Sensors degrade: the oxygen cell is consumed, electrochemical cells drift and the catalytic sensor can be poisoned. The functional test before use and periodic calibration are what make the reading valid. A zero reading from a damaged sensor is worse than having no instrument, because it gives false reassurance.
What the user sees
A display with four readings and a status indicator. If a reading rises or falls unexpectedly, the response is to get out and check from outside. Use and interpretation are the responsibility of trained personnel, in accordance with applicable regulations.
This guide is for information only. Work involving electrical hazards, heights or hazardous atmospheres must be carried out by qualified, authorized personnel in accordance with applicable regulations.