Short answer
Anisotropy means that a property does not have the same value in all directions. The opposite is an isotropic material, where it makes no difference in which direction you measure. Most structural materials and engineering insulators are anisotropic to some degree.
Why it appears
The cause lies in the internal structure. A glass cloth and resin laminate has oriented layers and fibers; a crystal has different atomic planes depending on the axis; an extruded or injection-molded polymer ends up with molecular chains aligned in the flow direction; pressed cellulose has a fiber direction and a thickness direction. Every manufacturing process leaves a directional “fingerprint.”
Which properties change
- Permittivity and loss factor: these can differ between the plane of the laminate and through its thickness.
- Dielectric strength: breakdown along layers or interfaces is usually different from breakdown perpendicular to them.
- Thermal conductivity and expansion: heat and expansion follow preferred paths.
- Mechanical properties: modulus and strength vary with fiber orientation.
What an engineer sees in practice
Two specimens of the same material can give different results simply because they were cut in different orientations. A part can deform or warp when heated because it expands more in one direction than in another. A datasheet that gives a single value without stating the direction is incomplete.
How to handle it
- Identify the direction relevant to the application: electric field through the thickness, along the surface, heat flow.
- Request or measure the property in that direction and record the orientation of the specimen relative to the original material.
- Use electrodes and test configurations consistent with actual use.
- Take anisotropy into account when designing distances, supports and tolerances.
When it does not matter as much
In homogeneous materials without texture, such as many glasses or dense fine-grained ceramics, the directional difference is small and can be neglected, although it is advisable to confirm this with data for the material.