24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How Is a Material Selected for a High-Voltage Connector?

To select a material for a high-voltage connector, you evaluate its dielectric strength, its resistance to tracking and partial discharges, its thermal and mechanical stability and its compatibility with the environment, together with the geometry and the insulation distances.

The material is one part of the system

In a high-voltage connector, the performance of the insulation depends as much on the geometry as on the material: clearances in air, creepage distances over the surface, electrode radii and the quality of the interfaces. A good material in a poor geometry fails, and a modest material in a careful design can comply. Selection begins by defining the voltage, the environment and the expected life.

Properties to evaluate

  • Dielectric strength and stability under field: with the material free of voids and cavities.
  • Resistance to tracking and erosion: key if contamination or moisture is present. It is assessed with the comparative tracking index and inclined plane tests.
  • Resistance to partial discharges and corona: organic materials degrade, while inorganic materials or those with mineral fillers hold up better.
  • Thermal stability: continuous temperature, peaks and cycling.
  • Moisture absorption: low, to preserve properties.
  • Mechanical strength and creep: to maintain contact pressure and interfaces over the years.
  • Chemical compatibility and ultraviolet resistance outdoors.

Common families

Filled engineering thermoplastics, epoxy thermosets, silicones, sealing elastomers and ceramics are used. Silicones stand out for their hydrophobic surface behavior. Ceramics stand out for their inertness to arcs and the environment. Each family brings trade-offs in processing and cost.

Interfaces matter

A gap between the connector body and the cable or seal is a site for partial discharges. Elastomers and fillers must fit under pressure and without trapped air.

How to verify the choice

  1. Review the material datasheet and its test data for the relevant properties.
  2. Validate the assembly with voltage, partial discharge and environmental cycling tests according to the product standard.
  3. Consider long-term aging.

Safety

The design, testing and handling of high-voltage connectors must be carried out by qualified personnel, in accordance with applicable regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer