24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

Why does corrosion appear on connectors after salt spray?

Corrosion appears on connectors because the conductive salt film and moisture attack the contact and plating metals, especially where there are galvanic couples, pores or worn plating.

The basic mechanism

Salt spray leaves a highly conductive electrolyte film on the connector. With that film in place, any potential difference between metals, or between areas of the same metal, drives a corrosion reaction. Chlorides also break down the passive layers that protect many metals.

Why connectors are vulnerable

A connector brings many adverse conditions together in a small space:

  • Dissimilar metals in contact: the body, contacts and platings form galvanic couples, in which the less noble metal corrodes faster.
  • Thin, porous platings: gold or nickel can have pores that leave the substrate, copper for example, exposed; it corrodes and forms products that emerge on the surface.
  • Crevices: between the housing, seal and terminals, electrolyte is retained and becomes more aggressive.
  • Wear: mating cycles scratch the plating and expose base metal.

What you see

White or greenish deposits, reddish oxides on ferrous parts and blackened contacts. These products are poor conductors, so contact resistance rises and the connector shows intermittent signals or voltage drops. In unsealed connectors, corrosion can advance underneath the insulation.

Where the defect originates

Often in the material and the process: insufficient thickness, a poorly chosen metal pair, lack of sealing, missing or unsuitable dielectric grease, or contamination before exposure. The test reveals the weak points in an accelerated way.

How to reduce it

Choose metals that are close together in the galvanic series, ensure adequate plating thickness and quality, use seals and protect the contact area with suitable compounds. Drainage is also designed so that electrolyte does not accumulate.

How to analyze the failure

It is advisable to measure contact resistance before and after, examine the part under a microscope and make a cross-section to see where the attack began. If the whole connector corrodes evenly, the problem lies in the material; if the corrosion is localized, it usually comes from pores, crevices or galvanic couples.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer