24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What Is a Reference Multimeter Used For?

A reference multimeter serves as a working standard for measuring voltage, current and resistance with low uncertainty, so that electrical equipment and sources of lower accuracy can be verified or calibrated.

An ordinary multimeter is used for diagnostics: it shows whether voltage is present or whether a circuit conducts. A reference multimeter works on the same measuring principle but with higher resolution, better stability and lower uncertainty, and it is kept under traceable calibration. It is used for comparing and calibrating, not for field work.

What sets it apart

  • High resolution: it shows more useful digits, which makes small differences visible.
  • Stability: its response changes very little with time and temperature, which makes its certificate reliable between calibrations.
  • Low nonlinearity and noise: better than in general-purpose equipment.
  • Input characteristics: high input impedance on DC voltage so as not to load the circuit being measured.
  • Additional functions: four-wire resistance measurement, which eliminates the effect of the leads.

Common uses

Verifying the output of voltage and current sources, calibrating lower-class multimeters, checking multifunction calibrators, measuring reference voltages, or evaluating resistors. In each case its function is to be the standard against which the comparison is made.

What the engineer sees in practice

The quality of the result depends on the setup: suitable leads, clean connections, no thermal voltages at the copper contacts and warm-up time before measuring. An excellent multimeter with poor technique produces deficient measurements. The appropriate range must also be used, because uncertainty is specified by range and function.

Limitations

  • It does not replace a reference source when a value must be generated; it only measures.
  • Its uncertainty is useful only if its calibration is current and covers the functions used.
  • For very special quantities, such as very low voltages or very high resistances, specific instruments may be required.

When working with hazardous voltages, the work must be done by qualified personnel following the applicable electrical safety regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer