What each one measures
A logic analyzer records only high and low states on many lines and presents them as timing diagrams and bus values. A mixed-signal oscilloscope adds a few digital inputs to an oscilloscope and retains the view of the analog waveform. They do not compete for the same task: they answer different questions.
When the logic analyzer wins
- Many channels: wide parallel buses, several buses at once or a system with many control signals.
- Very deep memory: lets you record long sequences of activity and find a rare event some time later.
- State analysis: samples with an external clock from the system itself and presents the data as bus transfers, not as continuous time.
- Complex triggering: multi-level event sequences, counters and conditions across many lines.
- Protocol decoding and analysis with dedicated tools.
When the mixed-signal oscilloscope wins
- When the cause may be electrical: a level that does not reach its target, a slow edge, a sagging supply. Only the analog view shows this.
- When you are working with few lines, as on a microcontroller with a few serial buses.
- When you want a single instrument that correlates a power supply, a sensor and logic activity on the same time base.
Questions that help you decide
- How many lines do I need to see at once?
- Do I suspect a signal integrity problem, or only a logic and protocol problem?
- Do I need to see the relationship with an analog voltage on the same trigger?
- How much activity do I need to record before and after the fault?
A common combination
It is common to start with the logic analyzer to locate the moment and the line where behavior diverges, and then move to the oscilloscope to study that signal in detail. The capability of one does not replace that of the other; they complement each other.