Why it exists
An electrical installation is not the same at every point. Near the service entrance, the supply impedance is low and a transient can release a great deal of energy; in remote circuits, by contrast, the impedance is higher and the available energy lower. An instrument that withstands a given overvoltage at one point can be dangerous at another. The category sums up that risk.
What the numbering indicates
It is expressed as a Roman numeral preceded by CAT. The higher the number, the closer to the power source and the greater the energy of a possible transient, so more is demanded of the instrument’s insulation. In general terms, the low categories correspond to signal or electronic circuits not connected directly to the mains, and the high ones to the service entrance and outdoor installations.
The category is not the voltage
The rated voltage indicates the maximum continuous value the instrument withstands. The category describes the transient overvoltage and the associated energy. They are stated together, for example a category at a given voltage, and the same instrument can have different categories depending on the working voltage. An instrument must not be used in a category or at a voltage higher than those marked.
What you see in practice
- Markings on the front of the instrument and on its test leads.
- Test leads with insulating shrouds, finger guards and tips with little exposed surface.
- High-breaking-capacity internal fuses in high-category equipment.
How to choose
- Identify where in the installation the measurement will be made.
- Select an instrument whose category and voltage cover that point.
- Use leads and accessories of equal or higher category; the assembly is only as good as its weakest element.
The category reduces risks; it does not eliminate them. Work on energized installations must be carried out by qualified personnel, with procedures and protective equipment in accordance with the applicable regulations.