24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What Causes Co-Channel Interference?

Co-channel interference occurs when two or more transmitters use the same channel at the same time within range of each other, so that each receiver also receives the signal that was not meant for it.

Origin of the problem

Co-channel interference arises because the spectrum is finite and frequencies are reused. To serve more users, a network repeats the same channel in different cells or access points; if they are too close together or use too much power, the signal from one reaches the other’s receiver at a level that is no longer negligible.

What causes it

  • Very dense reuse: few frequencies available for many transmitters, which is common in unlicensed bands.
  • Excessive power: raising power extends the reach of your own signal and also of the interference caused to others.
  • Antennas with wide lobes or poor orientation: they radiate toward areas where they are not needed.
  • Favorable propagation: atmospheric conditions or flat terrain that allow distant signals to arrive stronger than expected.
  • Other parties’ networks: neighbors who use the same channel and cannot coordinate.

How it is quantified

What determines whether a link works is not the signal power on its own but the ratio between the wanted signal and the sum of noise and interference, known as SINR. A receiver can correctly demodulate a weak signal if there is no interference, and fail with a strong signal if the interference is comparable. That is why increasing power rarely solves the problem.

What an engineer sees

In Wi-Fi-type networks, devices on the same channel share airtime: they wait for one another before transmitting, and the result is a very busy channel, lower speed and more latency even though the signal is good. In systems without that courtesy, such as point-to-point or cellular links, the interference raises the error rate and forces the system to drop to a lower modulation. A spectrum analyzer shows the other party’s carrier inside your own channel, and equipment statistics show retransmissions and a low negotiated rate.

How to reduce it

Channel allocation is planned so that nearby devices do not coincide, power is adjusted to the minimum necessary, more directional antennas are used and the channel is changed when a less busy one is available. It should not be confused with adjacent-channel interference, where the source is on a neighboring channel and the remedy is different, mainly filtering and separation.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer