24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

Dipole or Monopole Antenna?

A dipole is a two-arm antenna that needs no ground plane; a monopole is a single arm over a conductive plane that, by the image principle, behaves like half a dipole, with half the theoretical impedance.

The fundamental difference

A dipole consists of two arms fed at the center, each close to a quarter wave long in the case of a half-wave dipole. A monopole is a single quarter-wave arm mounted on a conductive surface. That surface acts as a mirror: by the principle of images, the monopole and its image in the plane form a dipole, but radiation occurs only in the upper half-space.

Design consequences

  • Impedance: the radiation resistance of an ideal monopole over an infinite plane is half that of the equivalent dipole.
  • Gain: since the energy is emitted into half of space, the gain of a monopole over an ideal plane is higher than that of a dipole, by a theoretical factor of two.
  • Ground plane: the monopole depends on it. If the plane is small or absent, the pattern is distorted and the cable or chassis becomes part of the antenna.
  • Feed: the dipole is balanced and usually needs a balun. The monopole is fed unbalanced, directly from a coaxial cable, with the shield on the plane.

What the engineer sees in practice

In the upper VHF band or at UHF, a monopole mounted on a vehicle roof or on a metal plate works well. In a small device without a sufficient plane, performance depends on the size of the printed circuit board or the housing. With a dipole, behavior depends less on the surroundings, although nearby objects also have an influence.

How to choose

  1. If the installation has a large, stable metal surface, the monopole is compact and simple.
  2. If the antenna must work isolated or without a reference, the dipole is the better choice.
  3. If vertical space is limited, shortened or loaded versions exist, at the cost of bandwidth and efficiency.

A point to verify

The theoretical figures assume an infinite, perfectly conducting plane. In a real measurement, the finite size of the plane changes the impedance and raises the pattern, so the value must be confirmed with the antenna installed.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer