24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What Is the Service Factor of a Motor?

A motor's service factor is a multiplier of rated power that indicates how much additional load it can handle continuously, under rated voltage, frequency and ambient conditions, with acceptable heating.

Definition

The service factor appears on the motor nameplate as a number equal to or greater than one. Multiplied by rated power, it gives the power at which the motor can run continuously at rated voltage and frequency and at the intended ambient temperature, without exceeding the heating its insulation allows. A factor of one means there is no overload margin.

What it represents physically

It is a thermal margin. A motor’s limit is the temperature of its insulation; the service factor indicates that the design has reserve to dissipate more heat than it generates at rated full load. That reserve does not come free: when it is used, the motor runs hotter and insulation aging accelerates.

When it applies and when it does not

  • It is guaranteed only with voltage, frequency and ambient at rated conditions; with imbalance, low voltage or high temperature, the margin is used up.
  • It should not be used as the regular design load. It is a backup for occasional overloads or load uncertainties.
  • With drive-fed motors, the thermal behavior changes and the service factor usually does not apply in the same way; consult the manufacturer’s information.
  • Above rated load, efficiency, power factor and speed change, and current rises more than proportionally.

Relationship with protection

The setting of overload relays is determined from the full-load current and the service factor, following the criteria of the applicable regulations. A setting that ignores the service factor can trip unnecessarily; one that exceeds it leaves the motor unprotected against damaging heating.

Common mistakes

  • Selecting a lower-power motor by counting on the service factor.
  • Assuming the service factor protects against imbalance or lack of ventilation.
  • Confusing it with the load factor, which is the ratio between actual load and rated load.
  • Thinking a higher factor means a “better” motor: it simply has more thermal reserve.

In practice, the measured current compared with the nameplate current is the first sign that the motor is running in its service range or is overloaded.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer