What it is for
IEEE 1159 is a recommended practice for power quality monitoring. Its greatest contribution is a common vocabulary and classification: it lets two engineers call the same phenomenon by the same name and makes an event report understandable to third parties. It also deals with instrumentation and the interpretation of monitoring data.
Categories of phenomena
- Transients: impulsive (such as those caused by lightning) and oscillatory (such as those from capacitor switching), distinguished by their frequency content and duration.
- Short-duration RMS variations: sags, swells and interruptions, subdivided by duration into instantaneous, momentary and temporary.
- Long-duration variations: undervoltages, overvoltages and sustained interruptions.
- Unbalance of voltage or current.
- Waveform distortion: DC offset, harmonics, interharmonics, notching and noise.
- Voltage fluctuations, associated with flicker.
- Power frequency variations on the grid.
How each phenomenon is characterized
For each category, the standard gives a typical spectral content, a typical duration and, where applicable, a typical magnitude. These are classification references, not acceptance limits: they serve to name and group events, not to decide whether an installation complies.
What an engineer sees in practice
The event reports of many recorders use these categories: for example, an event appears as a momentary sag or as an oscillatory transient. Knowing the classification helps you understand the record and choose the instrument: transients call for fast sampling, while RMS variations need only a half-cycle calculation.
What to do with this summary
This guide describes only the general scope. The duration and magnitude thresholds of each category can change between editions, so consult the current edition before citing values.