24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

EMC rental: magnetic and electric field probe set

Near-field probe kit (H20, H10, H5 and E5) for EMC pre-compliance measurements of radiated emissions, used together with a spectrum analyzer.

Magnetic and electric field probe set for EMC testing

Near-field probes for EMC

The kit includes a set of magnetic field and electric field probes for EMC pre-compliance measurements of radiated emissions. The H20, H10, H5 and E5 probes are magnetic field (H) and electric field (E) probes. They are used in the near field of electromagnetic radiation sources to locate and identify potential interference sources within the basic building blocks of electronic modules and assemblies.

The probes act much like wide-bandwidth antennas. They pick up radiated emissions from components, PCB traces, enclosure openings or gaps, and any other part that can emit RF. They are normally connected to a spectrum analyzer.

Scanning the probe over the surface of a PCB assembly or enclosure quickly identifies the places that emit electromagnetic radiation. Switching to a smaller probe narrows down the origin of the emissions further.

Other uses

  • RF immunity testing: an RF signal is fed to the probe and radiated toward potentially susceptible circuit sections.
  • Repair or debugging: locating problems in RF signal chains through non-contact measurement of their levels.
  • Non-invasive measurement of basic RF building blocks, such as modulators or oscillators. With a low-noise preamplifier, frequency, phase noise and spectral components can be measured.

The TBWA2/20dB and TBWA2/40db broadband amplifiers connect between the EMC probe and the spectrum analyzer.

Key features

  • Slim design that gives access to components that are very close together.
  • Shielded loops that help avoid picking up common-mode noise; not sensitive to the human hand.
  • Frequency range up to 6 GHz.
  • Insulated with a rubber coating.

Applications

  • Radiated EMC measurement
  • RF immunity testing
  • Non-contact (no-load) relative measurement of RF signal chains
  • Non-contact (no-load) relative measurement of oscillators, modulators, etc.
We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer