Purpose of the tests
The tests verify that the gloves provide adequate electrical insulation under normal working conditions and protect the user from accidental electric shocks. They make it possible to evaluate the voltage withstand, physical integrity and durability of the gloves over time and under extreme conditions.
Electrical insulation test
Purpose: to evaluate the ability of the gloves to withstand a voltage without dielectric failure, that is, without the glove letting electricity pass through it.
Method:
- The gloves are placed in a machine that applies a progressively increasing voltage until a predetermined level is reached.
- The test is performed according to the protection level of the gloves (class 00, 0, 1, 2, 3, 4), with test voltages that exceed the service values.
- During the test, the glove must withstand the voltage for a specified time (for example, 3 minutes) without showing any insulation failure.
Standard: ASTM F496-20, IEC 60903, EN 60903.
Dielectric glove test procedure
The process may vary depending on the type of test and the standard used, but in general the basic procedure includes these steps.
Glove preparation
- Initial visual inspection to detect obvious defects.
- Making sure the glove is clean and free of contaminants.
Performing the tests
- The corresponding test procedure is applied.
- In each test the results are recorded in detail, to ensure that the glove meets the established requirements.
Evaluation of results
- If the glove passes all the tests, it is considered suitable for use in electrical conditions.
- If any test fails (for example, the glove allows current to flow or shows visible defects), the glove is considered non-conforming and must not be used.
Results report
- A detailed report is generated documenting the test conditions, the results obtained and whether the glove met the safety specifications.
- This report serves as the basis for certifying the fitness of the gloves for electrical protection.
