What it is
An oil behaves almost like an ideal capacitor: the current through it leads the voltage by almost 90 degrees. Losses make that angle slightly smaller; the difference is called the loss angle, and its tangent is the dissipation factor, also called tan delta. It is equivalent to the ratio of the resistive loss current to the capacitive current. It is measured in a cell with concentric electrodes at power frequency and at a specified temperature.
Why it rises
A new, clean oil has very low losses, because it contains almost no charge carriers or polar molecules. The factor increases when the following appear:
- Oxidation and aging products: acids, sludge and dissolved polar compounds.
- Contamination: residues of varnishes, paints, gaskets or mixed oils.
- Water and particles: these add further conductivity.
- Dissolved or colloidal metals: for example, from copper catalysis.
Ionic conductivity dominates the losses, so the factor bears a close relationship to resistivity: when one rises, the other falls.
The role of temperature
The conductivity of oil increases with temperature, so the dissipation factor grows strongly on heating. That is why the test is carried out at a temperature defined by the method, and results can be compared with each other only if they were measured under the same conditions. Measuring cold can hide a deterioration that will show up when the equipment is hot.
What it reveals in practice
It is a test sensitive to dissolved contaminants that dielectric strength does not detect. An oil can have good strength and a high dissipation factor: it still insulates under a momentary voltage, but losses are higher and aging continues. A rapid rise between samples indicates a recent change, such as contamination or overheating.
How to interpret the result
- Compare with the value for new oil and with the criteria of the method.
- Observe the trend over time.
- Cross-check it with acidity, resistivity and water content to identify the cause.
The dissipation factor is a general clue, not a diagnosis in itself: it signals that the oil has degraded, and other analyses indicate why.