24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What causes an insulation fault on the high-voltage bus?

An insulation fault on the high-voltage bus is usually due to moisture or condensation, coolant leaks, insulation damaged by abrasion or heat, contamination in connectors, or deterioration of the motor winding.

What an insulation fault really is

A vehicle’s high-voltage bus is separated from the chassis by the insulation of cables, connectors, windings and components. A fault is a decrease in that resistance to a value the vehicle’s monitor considers unacceptable. It does not imply a short circuit or a discharge, but rather a leakage path that reduces the safety margin.

Most frequent causes

  • Water and condensation: water entering a connector or component, or the temperature cycling that produces internal condensation, creates a conductive path, especially if salts or dirt are present.
  • Coolant: if the cooling circuit runs through high-voltage components, a leak introduces a conductive liquid inside them.
  • Mechanical damage: cables chafing against edges, crushing, vibration or contact with hot surfaces that degrade the covering.
  • Contamination: conductive dust, manufacturing residues or corrosion products on terminals and busbars.
  • Motor windings: the insulation is degraded by the electrical stress of the inverter pulses, by temperature and by moisture.
  • Components with heating elements and filter capacitors: these can fail internally and become a leakage path.

How it shows up

A fault that comes and goes with rain, washing or temperature changes points to moisture. One that appears only with the heater or compressor on points to that component. A permanent fault on a single pole indicates localized damage.

What to check first

The location method works by elimination: subsystems are disconnected and insulation resistance is measured with a suitable meter until you see which one restores the value. Connectors, seals and cable routes are inspected, and evidence of leaks is sought.

The search is carried out on a system with lethal energy. It must be entrusted to qualified personnel, with the system deactivated and the absence of voltage verified, in accordance with the applicable regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer