24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is the I-V curve measured in the field?

A curve tracer is connected to the PV module or string and sweeps the load from short circuit to open circuit while irradiance and temperature are measured at the same time, so the results can be compared with reference conditions.

What the I-V curve is

The I-V curve of a module shows how the current it delivers changes with the voltage at its terminals. At one end is the short-circuit current; at the other, the open-circuit voltage; in between lies the maximum power point. The shape of the curve sums up the condition of the module: shading, soiling, degradation, damaged cells or poor connections distort it in recognizable ways.

How it is measured

  1. Verify that the system is safe to work on: modules produce DC voltage as soon as they receive light, and they cannot be “switched off”.
  2. Isolate the string or module and connect it to the tracer with suitable cables and connectors.
  3. Place the irradiance sensor in the same plane as the modules, with the same orientation and tilt.
  4. Measure the cell temperature, normally with a sensor attached to the back of the module.
  5. The instrument performs the sweep, which lasts a fraction of a second, and records the curve together with irradiance and temperature.
  6. The data are translated to reference conditions with correction equations so they can be compared with the datasheet.

Why irradiance and temperature matter

Module current is approximately proportional to irradiance, and voltage decreases as temperature rises. Without these two measurements, a degraded module cannot be distinguished from one that is simply hot or receiving little light.

What is interpreted

  • Low current across the whole curve: soiling, uniform shading or degradation.
  • Steps or notches: shaded cells or active bypass diodes.
  • Steep slope near the short-circuit current: losses from shunt resistance.
  • Voltage drop in the power region with normal current: high series resistance, often from connections.

Common errors

  • Measuring with passing clouds or irradiance that changes during the sweep.
  • Placing the sensor at a different tilt from the modules.
  • Estimating module temperature from ambient temperature instead of measuring it.
  • Comparing with manufacturer data without correcting to the same conditions.
  • Measuring recently exposed modules, with thermal gradients from shade or wind.

PV arrays carry dangerous DC voltages and arcs that are difficult to extinguish. The measurement must be carried out by qualified personnel, following the applicable safety regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer