The principle
Closing a valve or turning off a switch is not isolation. A valve can leak, someone can open it by mistake and a switch can be turned back on. Isolating means creating a physical, reliable, proven barrier between the space and anything that could harm whoever is inside.
What is isolated
| Source | Typical measure |
|---|---|
| Electricity | Disconnection, lockout with padlock and tag, verification of absence of voltage. |
| Mechanical energy | Stop and lock out agitators, conveyors and mixers, and prevent movement by gravity. |
| Hydraulic and pneumatic | Close, lock out and depressurize lines and accumulators. |
| Process fluids | Blind flanges, disconnection of pipe sections or double block and bleed. |
| Thermal | Allow to cool, cut off steam or heating sources. |
| Bulk materials | Prevent entry through feeders, hoppers or conveyors. |
Isolating fluids safely
There are three levels of safety. The most reliable is to physically disconnect the piping or install a blind flange. Next is double block and bleed: two closed valves with an open vent between them, so that any leak goes outside and does not enter the space. The weakest is a single closed valve, which is not considered sufficient when the fluid is hazardous.
Verification
- Test that the equipment does not start, by trying to operate it from its controls with the lockout in place.
- Confirm with an instrument that there is no voltage.
- Confirm that pressure has been released, using pressure gauges or vents.
- Review the diagrams and walk the physical lines to find connections that do not appear on the drawings.
Residual energy
After isolation, stored energy remains: trapped pressure, material that can fall, compressed springs, hot parts or charged capacitors. It is released or restrained in a controlled way.
Why it fails in practice
Failures usually come from an unidentified line, a lock removed by someone who did not know people were inside, or a valve assumed to be closed without verification. That is why each person applies their own padlock and the isolation is recorded on the permit. Electrical switching is done by qualified personnel, and the entire procedure must follow applicable regulations.