24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What is a two-pole voltage absence tester?

A two-pole voltage absence tester is an instrument with two probes that connect to the circuit, whose indication depends on the actual voltage between them, with a defined internal impedance that limits ghost readings.

Definition

A two-pole tester has two probes, one for each measuring pole. When they touch two points in the circuit, the instrument closes an internal path of defined impedance and shows whether a potential difference exists. It is designed specifically to confirm the presence or absence of voltage, not to measure accurately.

How it differs from other instruments

Instrument Main function Remarks
Two-pole tester Confirm presence or absence of voltage Clear indication, defined internal impedance
Multimeter Measure quantities accurately High impedance, may show ghost voltage, and its indication depends on the settings
Non-contact detector Warn of the presence of a field Does not prove the absence of voltage

Why internal impedance matters

Long circuits, or circuits parallel to other energized ones, can carry an induced voltage with very little ability to deliver current. A high-impedance instrument measures it and shows an apparent value. A lower-impedance tester places a slight load on the circuit: if the voltage was only induced, it drops almost to zero; if the voltage is real, it holds. This is how what represents a risk is distinguished.

Practical advantages

  • Unequivocal indication, with no ranges or functions to select that could be set incorrectly.
  • Many models include a self-test and a proving function with a built-in source.
  • Designed to be used with the appropriate measurement category and range.

Correct use

  1. Inspect the instrument and its probes.
  2. Test it on a known source.
  3. Measure between all the conductors that will be touched and from each one to ground.
  4. Test it again on the known source.

Limits

Some low-impedance models can trip residual-current devices when applied between phase and ground, so the behavior of the model must be known. For medium and high voltages, instruments and hot sticks designed for those levels are used. Their use is the responsibility of qualified personnel, in accordance with the applicable regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer