24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is an arc flash study performed?

An arc flash study models how much energy an arc would release at each point in an installation, using system data and protective device trip times, in order to define approach boundaries, protective equipment and improvements.

What the study aims to do

An electric arc releases thermal energy in the form of heat and radiation. The study estimates that energy at specific points (panels, control centers, circuit breakers) so that decisions can be made about what personal protection is required and which improvements would reduce the risk.

Typical stages

  1. Data collection: single-line diagrams, transformers, conductors, circuit breakers and their settings, panel configurations and working distances. The data must be verified in the field, because drawings are often out of date.
  2. Short-circuit study: the available fault current at each point is calculated, taking into account the contributions from the utility and from motors.
  3. Protective device coordination: the operating times of each device are obtained from its curves and settings.
  4. Incident energy calculation: using models from the technical literature, such as those in the IEEE 1584 guide, the energy is estimated as a function of arcing current, time, electrode configuration, enclosure and working distance.
  5. Arc flash boundary: the distance at which the energy falls to a level where an unprotected person could suffer a curable burn.
  6. Labeling and report: results for each piece of equipment, with recommendations.

Why time matters so much

Incident energy increases with arc duration. A protective device that trips quickly greatly reduces the result; one that is delayed because it is coordinated for selectivity can raise it. This creates a real conflict between coordination and energy reduction, which is resolved with techniques such as maintenance modes, bus differential protection or optical arc detection.

How to interpret the result

  • A high value on a piece of equipment shows where action is worthwhile: change settings, add devices or adjust procedures.
  • The result depends on the input data and on the system remaining as modeled; after changes to the installation, the study must be updated.
  • The label is information for making decisions; it does not replace the risk analysis for the task.

Safety note

Consult the current edition of the applicable methodology. The study and any work on equipment with an arc flash hazard must be carried out by qualified personnel following the applicable regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer