What it is for
Every task in an electrical installation has specific hazards that depend on the voltage, the available energy, the condition of the equipment and the surroundings. The risk analysis turns that information into decisions before anyone approaches the equipment, instead of improvising on site.
Stages of the analysis
- Define the task and its scope: what will be done, on which equipment and with which tools.
- Identify the hazards: contact with energized parts, arc flash, stored energy (capacitors, springs), backfeed from another source, work at height, confined spaces.
- Estimate the risk: combine the likelihood of the event with the severity of its consequences.
- Choose controls: actions to reduce the risk, ranked by effectiveness.
- Review the residual risk: decide whether it is acceptable with the planned controls.
- Document and communicate: the whole team knows the plan and their roles.
Hierarchy of controls
The logic is to prefer controls that eliminate the hazard over those that depend on human behavior:
- Eliminate: de-energize the equipment and place it in an electrically safe condition, with lockout and verification. This is the preferred control.
- Substitute or reduce: for example, work remotely or with equipment that has less available energy.
- Engineering controls: barriers, arc-resistant switchgear, remote operation.
- Administrative controls: procedures, signage, work permits.
- Personal protective equipment: this is the last barrier, not the first.
What the engineer sees in practice
A useful analysis form is not a copied generic list: it names the equipment, the energy state, the isolation method, the person in charge and the criteria for stopping work. If something changes during the task (another circuit, an unexpected condition, a finding on the equipment), the analysis is reviewed before continuing.
When not to continue
If the residual risk is not acceptable, if information about the equipment is missing or if it cannot be reliably isolated, the correct decision is to stop and rethink. Tasks involving electrical risk must be carried out by qualified personnel following the applicable regulations.