24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What is a vibration data collector?

A vibration data collector is a portable instrument that records vibration measurements at defined points on many machines following a route, stores them and transfers them to analysis software for viewing trends and diagnosing faults.

What it does

It combines a signal conditioner, an FFT analyzer and memory in a portable unit. The technician walks a preconfigured route: the collector indicates which point to measure, with which parameters and in what order, and saves the spectrum, the waveform and the overall levels of each measurement.

What is configured

  • Measurement points and directions for each machine.
  • Acquisition parameters: frequency range, resolution, averaging.
  • Alarms by band or by overall level, to flag deviations immediately.
  • Reference operating speed, needed to identify synchronous components.

Why repeatability is essential

The collector’s value lies in the trend. Comparing measurements from different months only makes sense if the point, the sensor mounting, the load and the speed are comparable. Changing the position or the attachment method can produce more variation than the deterioration of the machine itself.

What the engineer sees afterwards

The software is used to review overall level trends, overlaid spectra, waterfall plots and alarms. A gradual, sustained rise in a band associated with a component is stronger evidence than a single high value.

When it does not apply

A route measures at intervals, so a defect that develops faster than the interval can go unnoticed. On critical or rapidly deteriorating machines, continuous monitoring is justified.

How to interpret the result

Collector data are reviewed by exception: first the measurements that exceed alarms, then those that are changing faster than their history. An isolated out-of-trend reading is usually a mounting error, and it is repeated before drawing conclusions. When the change recurs, the spectrum is analyzed and cross-checked with other techniques.

Good practices

Physically marking the points, always using the same attachment method and recording the speed and load reduce variation that does not come from the machine.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer