It is a guide, not a test method
ASTM E1934 is presented as a guide. This distinguishes it from a test method with steps and acceptance criteria: it gives guidance on good practice so that the inspection is complete and reproducible, but leaves it to the organization to define its criteria and frequencies.
Topics it organizes
- Equipment and personnel: what characteristics the camera should have and what competence is expected of the person interpreting.
- Planning: what equipment to inspect, under what load conditions, and with what access.
- Measurement conditions: the influence of emissivity, reflections, wind, solar radiation, distance, and load.
- Documentation: what data to record so that someone else can understand and repeat the inspection.
- Report: how to communicate findings, with thermal image, visible image, and conditions.
- Safety: a reminder that inspections are usually done on equipment that is energized or in motion.
Example of how it is applied
On a walk through motor control centers, the guide supports practices such as confirming that the equipment is operating at representative load, recording the current at the time of the image, comparing similar phases or components, and reporting both the measured temperature and the context. On mechanical equipment, it applies in a similar way to bearings, couplings, and gear reducers, where the heating pattern is interpreted and compared with sister equipment or with the history of the same equipment.
What is left out
- It does not define universal acceptance temperature limits.
- It does not replace the thermographer’s judgment or safety regulations.
How to use it
It is taken as a reference for building your own procedures. Like any standard, it is revised periodically, so verify the text of the current edition rather than relying on summaries for specific requirements.