24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

Why Does a Material Have High Losses at High Frequencies?

A material has high losses at high frequencies because, as frequency rises, dipoles and charges no longer follow the field in phase, and this delayed response dissipates energy as heat; moisture, impurities and polar groups also play a part.

The physical origin

Dielectric losses appear when the polarization of the material is not in phase with the field. A dipole that has to reorient takes a characteristic time. If the field changes much more slowly than that time, the dipole follows the field and dissipates almost nothing. If it changes much faster, the dipole barely moves and does not dissipate either. Maximum losses occur when the two time scales are comparable, which is why a material can have a loss peak in a specific band.

Which materials have higher losses

  • Those with a polar structure: groups such as hydroxyls, carbonyls or amides reorient and produce relaxations. Nonpolar polymers, with high molecular symmetry, usually have the lowest losses.
  • Hygroscopic materials: absorbed water adds a strong relaxation in the microwave region.
  • Those with ionic conduction: mobile ions contribute losses that are significant at low frequency but persist across a wide band.
  • Those with defects and impurities: in ceramics, grain boundaries, vacancies and secondary phases.
  • Those with conductive or semiconductive fillers or pigments.

Material losses and circuit losses

In a printed line, attenuation comes from the dielectric, the conductor and radiation. Conductor losses increase with frequency because of the skin effect and copper roughness. An increase in attenuation therefore does not by itself prove that the material has high losses: the contributions must be separated.

What the engineer sees

The loss tangent increases with frequency in many common laminates, or shows a peak near a relaxation. The attenuation of a line grows faster than linearly in a certain band. A dependence on moisture indicates the contribution of water.

What to do

  1. Choose nonpolar or low-moisture-absorption materials.
  2. Condition the substrate and protect it from moisture.
  3. Measure the material at the frequency of use; do not extrapolate from low frequency.
  4. Evaluate copper roughness and the line design.
We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer