24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is the dielectric breakdown of an insulating sheet measured?

The dielectric breakdown of an insulating sheet is measured by applying a rising voltage between standardized electrodes until the material fails, and it is expressed as dielectric strength: breakdown voltage divided by thickness.

What is really being measured

The sheet is placed between two electrodes and the voltage is increased until a discharge punctures the material. The voltage at which this occurs, divided by the thickness, gives the dielectric strength. It is a statistical value, not a material constant: it depends on the thickness, the electrode shape, the waveform and the application time.

Elements of the setup

  • Electrodes: their geometry and rounded edges determine how much the field is concentrated. Standards specify shapes and dimensions.
  • Surrounding medium: with thin sheets, the assembly is usually immersed in insulating oil to prevent surface flashover at the edge, which would falsify the result.
  • Source: normally power-frequency AC voltage, or DC voltage or impulses depending on what is to be simulated.
  • Protection: a current limiter in the circuit reduces damage to the specimen after puncture and protects the source.

Ramp and failure criterion

The voltage is raised continuously or in steps at a defined rate. A faster ramp usually gives higher values than a slow one, which is why the rate is set in the procedure. Failure is detected when the current rises abruptly and the protection trips, and it is confirmed by observing the puncture hole.

What to expect in the results

A single test does not represent the material. Several specimens are tested and the median or mean is reported together with the scatter. Local defects, bubbles or contamination produce abnormally low values. It is also advisable to record the thickness measured at the test point, because dielectric strength decreases as thickness increases, and so values from sheets of different thicknesses cannot be compared without care.

How to interpret the number

Laboratory dielectric strength on a clean sheet is an upper bound. In service, voids, edges, partial discharges and aging reduce the voltage the material withstands, so designs apply wide margins, defined by the product standard.

Safety

This test involves high voltage and stored energy. It must be performed exclusively by qualified personnel, with facilities, interlocks and procedures that comply with applicable regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer