Definition
An insulator has no free charges that circulate, but it does have bound charges: electrons tied to their atoms, ions in a lattice and molecules with a dipole moment. When an electric field is applied, these charges shift slightly or orient themselves, creating dipoles that partly oppose the field. This effect is called polarization.
Why it matters
Polarization determines the permittivity of the material. A capacitor with a dielectric between its plates stores more charge at the same voltage than one with a vacuum, precisely because the material polarizes. The ratio of the capacitance with the material to the capacitance in vacuum is the relative permittivity.
Main mechanisms
- Electronic: the electron cloud shifts relative to the nucleus. It is present in all materials and is the fastest.
- Ionic or atomic: in solids with ionic bonds, positive and negative ions shift in opposite directions.
- Dipolar or orientational: molecules with a permanent dipole align with the field, against thermal agitation. It is slower and depends on temperature and viscosity.
- Interfacial or space charge: charges that accumulate at boundaries between phases, defects or electrodes. It is the slowest.
Frequency dependence
Each mechanism needs time to respond. As the field frequency rises, the slower mechanisms stop following it, and permittivity decreases in steps. At each step the energy absorbed by the material increases, which is reflected in dielectric losses. That is why the permittivity of a material is not a single number but a function of frequency and temperature.
What the engineer sees
The same material measured at low frequency and at radio frequency gives different permittivity values. When comparing a catalog figure with your own measurement, you must check the frequency and temperature of each one. Absorbed moisture adds dipolar and space-charge polarization, and usually raises permittivity and losses.
When it becomes a problem
Slow polarization causes dielectric absorption: a discharged capacitor recovers some voltage on its own. In high-frequency applications, polarization losses heat the material. It is evaluated by measuring permittivity and loss factor over the range of interest.