24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

Why does a product fail a humidity test?

A product fails a humidity test because water, whether absorbed or condensed, reduces insulation resistance, opens leakage paths and accelerates corrosion and electrochemical migration.

The short answer

Humidity acts in three ways: it enters materials and changes their properties, it forms water films on surfaces and, with contaminants, it creates electrolytes that enable corrosion and leakage currents. The failure results from the combination of water, voltage and contamination.

Most frequent mechanisms

  • Absorption in polymers and laminates: absorbed water raises the dielectric constant and losses, and lowers insulation resistance. It can swell the material.
  • Surface film: at high relative humidity a water layer of molecular thickness forms which, with ionic residues, conducts.
  • Corrosion: contacts, terminals and traces oxidize, increasing contact resistance.
  • Electrochemical migration: under bias, metal ions move between conductors and form dendrites that cause short circuits.
  • Condensation: when a surface temperature falls below the dew point, liquid water covers the circuits.

How it shows up

The first signs are leakage currents, erroneous readings from high-impedance sensors, noise or loss of communication. Then come restarts, intermittent short circuits or visible corrosion. Sometimes the equipment regains its function as it dries, which indicates a reversible effect, although corrosion damage is permanent.

Where the problem originates

It usually lies in the design and the process rather than in the chamber: flux residues on circuit boards, insufficient creepage distances, lack of conformal coating, poorly designed seals or hygroscopic materials. A clean, well-protected board tolerates much more than a dirty one.

How to investigate

First, compare insulation resistance and function before and after. Then examine under magnification for corrosion and dendrites, and analyze ionic residues. The test profile also counts: temperature changes produce condensation and tend to be more severe than stable humidity.

What to do with the result

Corrective actions range from process cleaning to redesigning the geometry, increasing distances, applying coating, choosing low-absorption materials or improving sealing. The solution must address the identified mechanism and be confirmed by repeating the test.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer