24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How a sample is monitored during a long-duration test

The environmental conditions and the behavior of the sample are recorded continuously with calibrated instruments, alarms and a response plan, in order to detect a failure the moment it occurs and understand how it developed.

Why checking at the end is not enough

In a long test, checking the sample only at the end tells you whether it failed, but not when or how. An intermittent failure that occurs one night and disappears can go unnoticed. Continuous monitoring turns the test into a data series that makes it possible to relate the failure to the conditions at that moment.

What is monitored

  • The environment: temperature, humidity and, where applicable, vibration, measured in the chamber and, if possible, on the sample.
  • The sample temperature, with sensors at the critical points.
  • Operation: current, supply voltage, output signals, error messages, communication.
  • Events: restarts, disconnections and protection trips.

Monitoring design decisions

  • Recording interval: it must be shorter than the event to be detected; a millisecond failure does not show up with one reading per minute.
  • Detection of intermittent faults: a system that captures time-stamped events, not just averages, is advisable.
  • Alarms: they warn if the chamber goes out of tolerance, if there is a power outage or if the sample fails, so that action can be taken before the test is lost.
  • Data and power backup: these prevent an outage from erasing days of testing.
  • Calibration of the sensors used for recording.

What the engineer sees

Good records reveal that a failure coincides with a temperature ramp, with the start of the chamber compressor or with a humidity peak. They also show the slow drift of a sample variable that anticipates the final failure. Without monitoring, this data is lost.

What to plan for

A procedure for what to do if a failure or a chamber deviation occurs: continue, pause or stop, and how to document the event. That criterion is defined before starting.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer