24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

RTD or thermocouple for a process?

The choice depends on the temperature range, accuracy, response time and mechanical conditions: the RTD usually wins on accuracy and stability, and the thermocouple on range, ruggedness and speed.

Neither is better in general

The right question is not which sensor is better, but which one meets the demands of the process. Each solves different problems well.

Comparison

Criterion RTD Thermocouple
Principle Variation in the resistance of a metal, usually platinum Voltage from the Seebeck effect between two metals
Accuracy and repeatability Generally better Generally lower
Long-term stability Good Can drift, especially at high temperature
Range More limited toward high temperatures Very wide, up to very high temperatures
Response Usually slower, depending on construction Can be very fast with fine wire
Ruggedness against vibration and shock More delicate More rugged
Signal Larger, measured as resistance Very small, sensitive to noise
Compensation Compensate for lead resistance Compensate for the reference junction
Cost of the assembly Sensor generally more expensive Inexpensive sensor, with special cable

How to decide

  1. Define the range. If the process exceeds what an RTD can withstand, the thermocouple is the option.
  2. Define the accuracy needed. For tight tolerances and stability, the RTD is usually preferable.
  3. Consider the environment. Intense vibration, thermal shock and aggressive atmospheres favor the thermocouple or a reinforced construction.
  4. Consider speed. A rapid temperature variation favors a low-mass thermocouple.
  5. Consider the cable run. A thermocouple requires extension cable of the proper type; an RTD requires three or four wires to compensate for resistance.
  6. Consider maintenance. Thermocouple drift may require more frequent replacements or checks.

An example

For a moderate-temperature process with tight control and stability, such as a bath or a heat exchanger, the RTD is a natural option. For a very high-temperature furnace, or one with vibration, the thermocouple is the reasonable alternative.

How to interpret the result

When both cover the range, the decision comes down to the required accuracy versus ruggedness and speed. They can be combined: an RTD as a reference and thermocouples for operation.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer