Where it fits
The IEC 61010 series deals with the safety of electrical equipment for measurement, control and laboratory use. The first part contains the general requirements; the 2 parts are particular requirements applied together with it to specific categories of equipment. Part 2-030 deals with equipment that has testing or measuring circuits, such as equipment connected to a circuit to observe or measure its signals, which includes oscilloscopes and other instruments.
What risks it addresses, in general terms
- Electric shock: accessibility of live parts, insulation, clearance and creepage distances, and protection against contact with terminals and input connections.
- Measuring terminals: requirements on their voltages, design and marking, so that the user knows how much can be applied.
- Fault conditions: what must happen if the equipment is connected to a circuit under conditions outside those intended, or if a higher voltage is applied to the input.
- Markings and instructions: information that the equipment and its documentation must include for safe use.
The relationship to measurement categories
The series classifies measurement environments into categories, according to the place in the installation where the measurement is made and the energy that can be released in the event of a fault. Equipment rated for a category and a voltage is designed to withstand the transients expected in that environment. This rating applies to the combination of instrument and accessories, and the element with the lowest capability sets the actual limit.
What an engineer should remember
The category and voltage marking on the instrument and on the probe is not decorative. Using an accessory of a lower category in a higher-category environment removes the intended safety margin. The standard sets requirements for the manufacturer; it does not replace user training or work procedures.
How to use it
Consult the current edition and confirm which parts apply to your equipment, because the series is revised and is organized into several parts. Measurements on energized circuits or at hazardous voltages must be made by qualified personnel, following the applicable safety regulations and using accessories with the appropriate category and rated voltage.