24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What is a differential probe?

A differential probe measures the voltage difference between its two inputs and rejects what they have in common, making it possible to measure between two points that are not referenced to the oscilloscope's ground.

What problem it solves

The normal oscilloscope input measures a signal with respect to its own ground, which is also tied to protective ground. If you connect the probe to a point whose return is at another voltage, a current flows through the ground connection, the circuit can be altered and the instrument can be damaged. A differential probe amplifies only the difference between its two terminals and delivers to the oscilloscope a signal referenced to its ground, so the circuit under test is left free of that connection.

Differential mode and common mode

If one input is at V1 and the other at V2, the useful signal is V1 minus V2 (differential mode), and what they share is the common mode. An ideal probe ignores the common mode completely. In practice, part of the common mode appears as error at the output. The common-mode rejection ratio (CMRR) expresses how well it is attenuated, and it worsens as frequency rises, so a low-frequency specification does not guarantee good rejection on a fast edge.

What to look for in the specifications

  • Maximum differential voltage: the limit between the two tips.
  • Maximum common-mode voltage: each tip with respect to ground. This is a different limit from the previous one and the one most easily exceeded.
  • Selectable attenuation: to match the range to the signal and preserve resolution.
  • Bandwidth and CMRR as a function of frequency.
  • Measurement category and voltage rating.

Where it is used

To measure across a power bridge, on floating gates in an inverter, on a current sense resistor away from ground, or on any network that has no node in common with the instrument. For a ground-referenced signal, on the other hand, a passive probe is usually simpler.

What to expect in practice

With a large common mode and fast edges, a spurious reading synchronized with the switching appears even if the differential signal is small. This is checked by joining both tips to the same node: what you then see is the common-mode error of the measurement. Measurements on energized circuits or circuits with hazardous voltages must be made by qualified people, following the applicable safety regulations and using accessories with the appropriate category and voltage rating.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer