24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What does IEC 61010-1 establish for measuring equipment?

IEC 61010-1 sets the general safety requirements for electrical equipment for measurement, control and laboratory use, in order to protect the user against electric shock, burns, fire and other hazards.

What it covers in general terms

The standard deals with the safety of the equipment and of the person using it. It covers measuring instruments, control equipment and electrically powered laboratory apparatus. It is a generic standard: other parts of the series add requirements for particular types of equipment.

What hazards it considers

  • Electric shock from accessible live parts.
  • Mechanical hazards, such as edges, moving parts or instability.
  • Excessive temperatures and fire spread.
  • Radiation, liquids, pressure and other hazards specific to the equipment.
  • Hazards arising from single faults, abnormal conditions or reasonably foreseeable misuse.

How it approaches safety design

The approach is that the equipment must remain safe after a single fault. It relies on concepts such as basic insulation, reinforced insulation, clearance and creepage distances, and protective earthing. These distances depend on the working voltage, the expected transient overvoltages and the pollution degree of the environment.

Measurement categories

The standard defines categories according to the point in the installation where an instrument is connected, from signal circuits up to the service entrance. This determines what transient overvoltage it must withstand. A low-category instrument is not suitable for a point in the installation with more energy available, even if its rated voltages seem sufficient.

What the engineer sees in practice

It shows up in the instrument markings: category symbols, maximum voltage to ground, insulation class and warnings. It also shows up in test leads with shrouds, finger guards and fuses with adequate breaking capacity. Choosing accessories that do not match the instrument’s category reduces the safety of the whole setup.

When it does not apply

It does not replace installation regulations or work procedures. For exact requirements, limits and test methods, consult the current edition of the standard. Work on energized circuits is the responsibility of qualified personnel in accordance with the applicable regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer