24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How do you build an automated test bench?

An automated test bench is built by defining what is measured and against what criterion, choosing instruments with a programmable interface, connecting them to the unit under test through a fixture and switching, and controlling it all with software that runs the sequence and records the results.

Start with the requirement

An automated bench does not start with instruments, but with the list of what must be verified, to what tolerance, in how much time and with what traceability. From that come the quantities to measure, the stimuli needed and the time available per unit, which determine the architecture.

Components

  • Instruments: power supplies, multimeters, generators, oscilloscopes and loads, among others, with a programmable interface such as USB, LAN or GPIB. The uncertainty of each instrument must be smaller than the tolerance to be verified, with margin.
  • Switching: relays or matrices that route the instruments to different points on the unit under test. They add resistance, capacitance and settling time, which must be taken into account.
  • Fixture: the mechanical and electrical device that connects the unit to the bench repeatably. It must have reliable contacts and be maintained.
  • Software: controls the instruments through standard commands, runs the sequence, compares against limits and saves the results.

Execution

The sequence usually consists of energizing, waiting for stabilization, configuring instruments, measuring, comparing and de-energizing. Wait times are critical: measuring before settling gives unstable readings, and waiting too long lengthens the cycle. The software must handle errors, such as an instrument that does not respond or a unit that does not start, and bring the system to a safe state.

Data and reliability

  • Record each measurement with the unit, the time, the sequence version and the instruments used.
  • Schedule periodic verifications of the bench with known standards.
  • Keep instrument calibration current and traceable.
  • Plan maintenance interventions for fixtures and relays, which wear out.

Safety

If the bench handles hazardous voltages, it must incorporate interlocks, protections and procedures designed by qualified personnel in accordance with the applicable regulations.

Common mistakes

  • Choosing the instruments before setting the requirements.
  • Ignoring the settling time of the switching.
  • Not validating the bench with known reference units.
  • Piling test logic and instrument logic into a single block of code that is hard to maintain.
We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer