How it arises
A radio wave rarely travels only in a straight line. It reflects off walls, the ground, vehicles and structures, diffracts at edges and scatters off small objects. The receiver picks up the sum of all those copies. Each one arrives with its own amplitude, delay and phase. If two copies arrive in phase they reinforce each other; if they arrive in opposition they cancel partially or completely. Since the phase depends on the path length measured in wavelengths, a displacement of a fraction of a wavelength is enough to go from reinforcement to cancellation.
Two different effects
- Flat fading: it affects the whole signal band almost equally. The level rises and falls as a block.
- Frequency-selective fading: it occurs when the signal bandwidth is comparable to or greater than the inverse of the delay spread between paths. Some frequencies in the channel are heavily attenuated and others are not, which causes intersymbol interference.
If the transmitter, the receiver or the reflectors move, the pattern changes over time and fast fading appears, associated with the Doppler effect. In a fixed environment, the pattern can change with minimal displacements of the antenna.
What the engineer sees
In an indoor link, the signal strength changes when the antenna is moved a few centimeters. On a spectrum analyzer, a notch may be visible in the occupied band. In the constellation, scattered points can be seen without much noise being present, because the cause is channel distortion and not thermal noise.
How it is countered
- Antenna, frequency or time diversity: if one path fades, another probably will not.
- Equalization: the receiver estimates the channel and compensates for its distortion.
- Multicarrier modulation: it divides the band into narrow subcarriers that each see a nearly flat channel.
- Fade margin: extra power is left in the link budget.
- Coding and interleaving: they spread errors out so they can be corrected.
When it is not the cause
A slow, monotonic variation when the weather or vegetation changes is usually due to other mechanisms, such as absorption or atmospheric refraction. It is worth distinguishing between the two before taking action.