24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is EMC addressed in battery-powered equipment?

It is addressed as in any other equipment, by identifying sources, coupling paths and victims, with the difference that no mains supply is connected in normal use, while switching converters, a charger and cables acting as antennas are present.

What changes with a battery

A battery eliminates the mains cable as the main noise path during operation, but it does not eliminate the sources. The problem moves into the equipment and toward its signal cables. In addition, much portable equipment is floating: it has no clear reference to ground, and that changes how common-mode currents behave.

The usual sources

  • Switching converters: boost and buck converters generate high-frequency noise with their fast edges and their switching current loop.
  • Clocks and digital processors: they radiate through traces, cables and openings in the housing.
  • Motors and actuators: they generate arcing and transients.
  • Integrated radios: they can interfere with the device’s own electronics.

Coupling paths

Common-mode noise flows along signal, sensor or charging cables, which act as efficient antennas even when the board is small. A USB cable or a long harness turns modest noise into notable radiated emission.

The charger case

When the equipment is connected to its charger, there is once again a connection to the mains. Two states are often evaluated: operating on battery and charging. Equipment that complies well on battery can fail while charging because of charger noise or the new common-mode path.

Immunity

Portable equipment is handled by hand, and electrostatic discharge is a real threat. It must also tolerate radio-frequency fields from nearby radios. Typical symptoms are resets, display freezes or erroneous sensor readings.

Design measures that usually work

  • Small switching current loops and continuous reference planes.
  • Filtering on every cable leaving the housing, and decoupling close to integrated circuits.
  • A proper connection between the chassis or shield and the board reference.
  • Housings with controlled seams and openings.
  • Electrostatic discharge protection on accessible ports.

Common mistakes

  • Assuming that “on battery there is no EMC problem.”
  • Testing only with the shortest cable configuration, when real use includes accessories and long cables.
  • Not testing the charging mode or the different operating states.
  • Leaving diagnosis to the final test instead of doing early pre-evaluations.

High-capacity lithium batteries also require safe handling by trained personnel.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer