What it measures
Not all the power reaching an antenna leaves as an electromagnetic wave. Part of it is lost in the resistance of the conductors, in the dielectric materials of the structure and in the contact between parts. Radiation efficiency is the quotient of the radiated power and the power accepted at the terminals. It equals one in a lossless antenna and is lower in real ones.
Relationship with other quantities
- With gain. Gain is radiation efficiency multiplied by directivity. Low efficiency reduces gain even if the pattern is directive.
- With resistance. The input impedance can be divided into a radiation resistance, which represents the power going into space, and a loss resistance. Efficiency is the quotient of the radiation resistance and the sum of the two.
- With total efficiency. Total efficiency also includes the mismatch loss between the antenna and the feed line. This is what really matters when you want to know how much transmitter power reaches the air.
When it is low
Electrically small antennas are the most susceptible. When an antenna is much smaller than the wavelength, its radiation resistance is very small and any loss resistance, however modest, dominates. That is why small antennas built into devices have low efficiencies, and the losses get worse with proximity to the body, to enclosures or to printed circuit boards. Materials with high dielectric losses and poor solder joints also contribute.
How it is estimated
- By integrating the measured three-dimensional pattern to obtain the total radiated power and comparing it with the input power.
- By comparing the measured gain with the directivity calculated from the pattern.
- With techniques specific to small antennas, such as a shield enclosing the antenna that makes it possible to separate out the loss resistance.
How to interpret the result
Good return loss does not guarantee good efficiency: an antenna can be well matched and radiate little, because the accepted power is dissipated. For this reason, an antenna with an excellent S11 can give a poor link. Efficiency or gain measurement complements matching measurement and cannot be replaced by it.