24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What Does the IEC 60153 Standard for Waveguides Cover?

IEC 60153 is a series of standards on hollow metallic waveguides: general requirements, measurement methods and specific dimension and tolerance specifications for the most widely used waveguide types.

The problem it solves

A waveguide is bought, measured and replaced by its dimensions. If two suppliers manufacture the same band with different tolerances, the components are not interchangeable and the measurements are not comparable. The IEC 60153 series exists to give a common language to manufacturers and users of hollow metallic waveguides, which are the basis of high-power and low-loss microwave systems.

What it contains in broad terms

  • General requirements and measurement methods. Defines how the properties of a waveguide are verified, including dimensions, attenuation and reflection.
  • Specific specifications by type. There are parts dedicated to ordinary rectangular waveguides, flat-section waveguides and circular waveguides, which set the nominal dimensions, materials and tolerances.

Flanges are normally covered in a separate series of standards; the 60153 series focuses on the waveguide tube. For that reason, when specifying a complete section it is advisable to state the waveguide and the flange separately.

Why these dimensions matter in measurement

In a rectangular waveguide, the larger dimension of the cross-section determines the cutoff frequency of the fundamental mode, and the ratio between the two dimensions sets the interval in which only that mode propagates. A deviation from the tolerances modifies the cutoff, the waveguide impedance and the reflection at each joint. In a network analyzer sweep, this appears as a shifted cutoff or unexpected ripple in the return loss when sections of different origins are joined.

The roughness of the inner surface and the material influence attenuation, since the losses come from the currents in the walls. That is why the standards set finishes and materials for each specification.

How to use this information

This guide describes only the general scope. Specific dimensions, tolerances, parts and test methods depend on the edition and part of the standard, and must be consulted in the current edition. Additional specific standards exist for very high frequencies, and a complete specification must state which one it refers to.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer