The fundamental difference: receiver versus stimulus-response system
A spectrum analyzer is essentially a receiver. It sweeps or processes a frequency interval and displays the power of whatever reaches its input. It does not need to know where the signal comes from, which is why it works for unknown signals: carriers, harmonics, spurs, interference and noise.
A vector network analyzer (VNA) combines its own source with several receivers. It sends a test signal to the device under test and compares the incident wave with the reflected and transmitted waves. What it delivers are ratios, not absolute powers: S-parameters, with magnitude and phase.
What each one measures
| Aspect | Spectrum analyzer | Network analyzer |
|---|---|---|
| Signal source | None, except for an optional tracking generator | Built-in and controlled |
| Typical result | Amplitude versus frequency of the signals present | S-parameters: reflection and transmission |
| Phase | Not measured in a classic sweep | Measured, with a coherent reference |
| Calibration | Of the instrument’s level and frequency | Vector error correction with standards, up to the device plane |
| Used for | Emissions, spurs, occupied bandwidth, modulation | Filters, antennas, cables, linear amplifiers |
What the engineer sees on the screen
With a spectrum analyzer you see a trace with peaks: each peak is a signal and its height is its level. The noise floor and the resolution determine how small the visible signals can be. With a network analyzer you see the response of a device, for example the insertion loss of a filter or the return loss of an antenna, and that response is repeatable because the stimulus is known.
A spectrum analyzer with a tracking generator can measure the transmission of a device, but only as a scalar magnitude: there is no phase and no reflection measurement with vector correction. That is why its accuracy is lower than that of a VNA.
How to choose
- If the question is what is on the air or on a cable, and how strong it is, use the spectrum analyzer.
- If the question is how a component behaves, or how well matched it is, use the network analyzer.
- If the device is nonlinear, such as an amplifier near compression, a classic VNA measures only its small-signal behavior; for the rest you need specific modes or a spectrum analyzer with calibrated sources.