24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What is rated withstand voltage?

Rated withstand voltage is the test voltage value that insulation must resist, without disruptive discharge, under standardized test conditions; it is not the operating voltage.

Rated withstand voltage refers to a capability, not a working condition. It is the voltage level that a piece of equipment or an insulation system must tolerate during a defined test without a disruptive discharge, that is, without the insulator losing its dielectric strength and an arc passing through or over it.

Why it differs from operating voltage

In service, insulation faces the nominal system voltage plus the overvoltages that appear sporadically: breaker switching, ground faults and lightning. The withstand voltage is set above the operating voltage to leave a margin for those events. A piece of equipment can work at its rated voltage for its entire life and still need a much higher withstand level to survive a single severe overvoltage.

Types of withstand voltage

Each type of overvoltage is represented by a different test waveform:

  • Short-duration power frequency: represents low-frequency temporary overvoltages. It is applied for a limited time.
  • Lightning impulse: a very fast-fronted wave that mimics a lightning strike. It is expressed as a peak value.
  • Switching impulse: a slower wave, relevant above all in high-voltage systems, where switching generates significant overvoltages.

What is seen in practice

The nameplate or data sheet of power equipment shows the maximum equipment voltage and the associated withstand levels. For the engineer, these values serve three decisions: comparing the insulation against the protective level of the surge arresters, defining the insulation clearances in air and defining the acceptance test program.

A withstand test is pass/fail: if there is no disruptive discharge, the equipment complies. This distinguishes it from a diagnostic measurement such as insulation resistance, which delivers a value and a trend, not a withstand verdict.

A criterion for interpreting it

Withstand voltage also depends on environmental conditions. Air density, humidity and contamination alter the strength of external insulation, so the relevant standards define corrections and reference conditions. Always consult the current standard applicable to the equipment.

Withstand voltage tests involve hazardous voltages. They must be performed only by qualified personnel, following the applicable safety regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer