What it is for
Shielded power cables are installed and age far from any laboratory, and evaluating them in the field poses problems of its own: long lengths, accessories installed in situ and ambient noise. IEEE 400 gathers criteria and methods for these tests and helps in choosing which is appropriate for the objective.
General scope
- Test types: it distinguishes installation, acceptance and maintenance tests, with different objectives at each stage of the cable’s life.
- Withstand and diagnostic tests: it describes both those that verify that the insulation withstands a stress level and those that measure condition parameters.
- Voltage sources: it covers the options for applying voltage, such as DC, very low frequency AC or AC at grid frequency.
- Measurement techniques: it includes aspects of insulation resistance, dissipation factor, partial discharge and fault location.
Each technique is complemented by an approach to how the measurement is performed and what its advantages and limitations are.
How it is used in practice
An engineer consults the guide to decide which test to apply to a new cable after installation, which diagnostic to perform on an aged cable and what type of source to use. It also serves as a basis for drafting internal procedures and for discussing criteria with suppliers.
When it does not apply
The guide does not replace the manufacturer’s specification or the cable product standard, and does not by itself set the acceptance values for a specific installation: those are defined by the owner, the project specification or the applicable standard. Nor does it cover all cable types or all situations.
It is recommended to consult the current edition of the document and verify its applicability to the installation.
These activities involve hazardous voltages: they must be carried out by qualified, authorized personnel, following the applicable regulations and the facility’s lockout and grounding procedures.