How it forms
- Contamination (salt, dust, industrial products) settles on the surface of the insulator.
- Moisture, such as fog, dew or drizzle, makes that layer conductive, and a leakage current flows across the surface.
- The current heats the layer and dries out areas that form dry bands. Almost all the voltage concentrates across those bands.
- The field across the dry band produces small surface discharges.
- The heat from the discharges decomposes the organic material of the insulator and leaves carbon, which is conductive. This is how a carbonized track forms.
- The track grows, shortens the effective distance and makes new discharges easier, until it can bridge the electrodes and cause a flashover.
Why it is permanent
Carbon does not recover. Once a conductive track exists, the insulator has a path predisposed to failure, and cleaning the surface does not restore the damaged material.
Tracking and erosion
Two modes of surface damage are distinguished. In tracking, carbonized conductive paths form. In erosion, material is lost through wear without forming a continuous conductive path. Some materials are more prone to one or the other. Tracking and erosion resistance tests are used to compare materials.
What influences it
- Material: organic materials are more susceptible than porcelain and glass, which do not carbonize; some polymers incorporate fillers that improve their resistance.
- Profile: insulators with sheds increase the creepage distance and protect areas from rain.
- Hydrophobicity: a water-repellent surface forms droplets rather than a continuous film, which hinders leakage current.
- The contamination level of the environment.
How to prevent it
- Select the creepage distance according to the contamination level at the site.
- Clean periodically or apply suitable coatings.
- Choose materials with good tracking resistance.
- Control humidity and condensation in enclosures and panels.
What is observed
Dark branching or carbonized lines on the surface, burned areas, audible discharges in wet weather and, with an ultraviolet camera, activity on the insulator.
Warning: inspection and cleaning near energized insulators must be done by qualified personnel, in accordance with applicable regulations.