Cable insertion loss with a microwave network analyzer
We measure insertion loss in SWR cables and in other radio frequency devices, such as amplifiers, couplers, attenuators and filters.
What insertion loss is
Insertion loss is the decrease in transmitted signal power caused by inserting a device in a transmission line or optical fiber. It is generally expressed relative to the signal power delivered to the same point before insertion, and is measured in decibels (dB).
Return loss is the ratio, at the junction of a transmission line and a terminating impedance or other discontinuity, between the amplitude of the reflected wave and that of the incident wave. It describes the reduction of the reflected energy compared with the forward energy.
Tektronix communication network test equipment
Tektronix bit error rate testers help shorten product development cycles and reduce the cost of verification testing. They make it possible to quickly identify errors in digital bit streams.
- BERTScope BSA series, Bit Error Testers: an approach to measuring the signal integrity of serial data systems that combines the certainty of a BERT with the insight of an oscilloscope.
- BERTScope CR series, clock recovery instruments: flexibility and precision for compliance measurements, in conjunction with bit error rate testers and sampling oscilloscopes.
- BERTScope DPP series, digital pre-emphasis processor: takes the data and clock inputs from a single terminal and conditions the signal by adding controllable amounts of pre-emphasis, for use with a bit error rate tester.
- BitAlyzer BA series, bit error rate testers: address the signal integrity and BER problems of designers of sophisticated electronic systems and satellite communications.
