Arc flash protective equipment in stock
We have complete personal protective equipment in Monterrey. Arc flash protective equipment is IN STOCK from well-known brands such as Salisbury, Honeywell, Arc Gear, Oberon and others, in compliance with ASTM F1506 ARC and NFPA 70E. Rental or sale of new and used equipment, with immediate delivery from stock.
The equipment meets ANSI / ISEA 125 Level 2 conformity standards and is Category 4+ arc flash PPE, with an arc rating of up to 65 cal/cm2. Consult the NFPA 70E or CSA Z462 standards for specific selection requirements.
Arc flash protection standard
ASTM F1506 is the standard performance specification for flame-resistant, arc-rated protective clothing worn by workers exposed to flames and electric arcs. It is cited in OSHA 1910.269, NFPA 70E and CSA Z462.
Arc flash accidents are the most common and least visible, yet fatal, risk for users and operators of electrical equipment. According to statistical information, this phenomenon is the third leading cause of death in the electrical industry, with 25 percent of fatalities.
How heat protection is measured
When buying arc flash clothing, you must define the level of protection you need. Suits, gloves, hoods and other garments offer different levels. That level is related to the Arc Thermal Performance Value (ATPV), which is measured in calories per square centimeter (cal/cm2).
A 40 cal arc flash suit is rated to protect against incident heat energy of up to 40 cal/cm2. Our arc flash clothing is rated between 40 cal/cm2 at the lower end and 65 cal/cm2 at the upper end. Higher numbers offer more protection.
According to the American Transmission Company, one cal/cm2 of thermal energy is roughly equivalent to holding your finger in the flame of a candle or lighter. A 40 cal/cm2 suit is designed to absorb thermal energy 40 times more intense.
An arc flash hood or suit does not always prevent injury. The ATPV rating indicates a fabric’s ability to absorb thermal energy, but it does not neutralize that energy completely, so a worker could still be burned. The goal is to minimize the thermal energy that reaches the skin: clothing is rated by its ability to limit the injury to a second-degree burn. A 40 cal/cm2 suit can absorb the energy of a 40 cal/cm2 incident and protect the wearer from anything worse than a second-degree burn.
Assess your risk level
When choosing a hood, suit, gloves or other garment, consider the ATPV rating. You need a suit capable of withstanding the maximum potential level of incident thermal energy of the electrical system where you will use it. Higher-voltage systems have more potential incident heat energy and require suits with more cal/cm2. If you have questions about the ratings or how to choose, call us and speak with the engineer.
Labeling of electrical equipment
Article 110.16 of NFPA 70, the National Electrical Code (NEC), states that relevant electrical equipment must be marked to warn qualified persons of arc flash hazards. Labeling is mandatory on any electrical machine that is inspected, adjusted, repaired or maintained while energized, because an arc flash incident can occur. For this reason, many employers also label busways and other equipment that the NEC does not specifically mention. The NEC gives these examples of equipment that must carry a warning label:
- Switchboards.
- Panelboards.
- Motor control centers.
- Industrial control panels.
- Meter socket enclosures.
- And more.
